Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998INTEGRA RS, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 16 (ENGINE CONTROLS - TESTS W/CODES)SELF-DIAGNOSTIC SYSTEMRETRIEVING CODESUSING SCAN TOOL
1998 Acura Integra RS, Automatic
Using Scan Tool
1998 Acura Integra RS, AutomaticSECTION Using Scan Tool
WARNING: This page is about a different car, the 1998 Acura 2.5TL. However, it is still accessible from the selected car via links, so may be relevant.
Locate Data Link Connector (DLC) in center console, behind ash tray. See Fig 1 . Connect and operate scan tool in accordance with manufacturer's instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.