Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Honda Accord (1998) & Civic
1998 Acura Integra RS, AutomaticSECTION Honda Accord (1998) & Civic
- Turn ignition off. Remove center console. Disconnect parking pin switch 4-pin harness connector, located near shift lock solenoid harness connector.
- Ensure shift lever is in Park. Using a DVOM, connect DVOM to parking pin switch harness connector terminals No. 3 (Black wire) and No. 4 (White/Black wire). Push shift lever button. Continuity should exist. Release shift lever button. Continuity should not exist. If continuity is not as specified, replace parking pin switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.