Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998INTEGRA RS, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICAL1.8L 4-CYL - GS/LS/RSOVERHAULCYLINDER BLOCK ASSEMBLYPISTON PIN INSTALLATION
1998 Acura Integra RS, Automatic
Piston Pin Installation
1998 Acura Integra RS, AutomaticSECTION Piston Pin Installation
- Ensure piston and connecting rod are positioned as shown in illustration. See Figure. Turn handle on Piston Pin Driver (07973-PE00320) so piston driver length is 1.957" (49.70 mm).
- Install Pilot Collar (07LAF-PR30100) into piston and connecting rod. Lightly lubricate new piston pin. Place piston onto base. Press in piston pin.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.