Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998INTEGRA RS, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER MIRRORSSYSTEM TESTINGFUNCTIONAL TESTLEFT MIRROR INOPERATIVE (2.5TL)
1998 Acura Integra RS, Automatic
Left Mirror Inoperative (2.5TL)
1998 Acura Integra RS, AutomaticSECTION Left Mirror Inoperative (2.5TL)
- Connect a jumper wire between 10-pin connector terminal No. 9 (Yellow/Black wire) and terminal No. 7 (Yellow/White wire). See Figure. Connect jumper wire between 10-pin connector terminal No. 5 (Blue/White wire) and ground. Turn ignition on. Left mirror should tilt down. If mirror does not tilt down, check for open in Blue/White wire. If wire is okay, go to next step.
- Turn ignition off. Move jumper wire from 10-pin connector terminal No. 5 (Blue/White wire) to terminal No. 4 (Light Green wire). Turn ignition on. Left mirror should swing left. If mirror does not swing left, check for open in Light Green wire. If wire is okay, check left mirror motor. See POWER MIRROR MOTOR TEST under COMPONENT TESTS. If mirror does not tilt down and does not swing left, check for open in Yellow/White wire. If mirror operates correctly, check power mirror switch. See POWER MIRROR SWITCH TEST under COMPONENT TESTS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.