Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998INTEGRA GS, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (COMPUTER RELEARN PROCEDURES)MAZDAIMMOBILIZER SYSTEM (626)REPROGRAM ERROR RECOVERY
1998 Acura Integra GS, 4D Sedan, Automatic
Reprogram Error Recovery
1998 Acura Integra GS, 4D Sedan, AutomaticSECTION Reprogram Error Recovery
WARNING: This page does not describe the selected car, but rather 135 other vehicles, including the 2000 Volvo V70, 2000 Volvo V40, 2000 Volvo S80, 2000 Volvo S70, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Using 1st key, start engine. After SECURITY light illuminates for 1-2 seconds, turn 1st key to LOCK position. Using 1st key, turn ignition to ON position, then LOCK position 5 times.
- Using 1st key, turn ignition to ON position. SECURITY light should illuminate. Turn 1st key to LOCK position and remove key. SECURITY light should go out.
- Using 2nd key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn 2nd key to LOCK position and remove key.
- Repeat step 3) with 1st key. Repeat step 3) with 3rd key. Repeat step 3) with each new key, up to 8 keys total. Wait 30 seconds, program will quit automatically. After reprogramming is complete, clear DTCs with NGS tester.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.