Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSDIAGNOSIS - M5DADTC/FLASH CODE TESTSDTC P0740/FLASH CODE 40: SHIFT CONTROL SYSTEM
1998 Acura 3.5RL Special Edition
DTC P0740/Flash Code 40: Shift Control System
1998 Acura 3.5RL Special EditionSECTION DTC P0740/Flash Code 40: Shift Control System
NOTE:
Ensure other DTC is diagnosed first before proceeding this test.
- Test 1st, 2nd, 3rd and 4th clutch pressure. See ACURA M5DA OVERHAUL article. Repair as necessary. If clutch pressure readings are as specified, go to next step.
- Replace shift control solenoid valve "A" and "B" assembly and linear solenoid assembly. Reset PCM memory. See CLEARING FAULT CODES . After clearing DTC, drive vehicle at more than 12 MPH in 1st, 2nd, 3rd and 4th gear for longer than 30 seconds in "D4" position. Recheck for DTC P0740/FLASH CODE 40. If DTC resets, replace transaxle. If DTC does not reset, system is okay at this time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.