Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Audio Unit Anti Theft Code Labels Applications (98-004)
Reference number: 98-004
AUDIO UNIT ANTI THEFT CODE LABELS APPLICATIONS
TECHNICAL SERVICE BULLETIN
| ACURA: | 1998-2000 All CL, RL, TL and Integra |
| CATEGORY: | Maintenance/PDI |
| APPLIES TO: | All |
BACKGROUND
This service bulletin describes where to attach the audio unit anti-theft code labels that come in the glove box of vehicles equipped with anti-theft audio systems.
If a vehicle is equipped with an anti-theft audio system, there are three peel-off labels in the glove box. Fig 1 . Two of the labels have both the anti-theft code and the audio unit's serial number, and a third label contains only the serial number for the audio unit.
During TQI, stick the label with only the serial number on the outer-left surface of the glove box. If the radio code ever needs to be retrieved through the ACURALINK 2000 system, this will save you the time and labor of removing the audio unit to record the serial number.
- Also perform this procedure when installing an accessory audio unit that is equipped with an anti-theft system.
- If a remanufactured audio unit is installed in a vehicle, remove the old labels and install new ones on the glove box, Radio Identification Card, and the vehicle's service records.
- If the glove box is ever replaced, transfer the label from the old glove box to the new one.
WARRANTY CLAIM INFORMATION
None. This bulletin is for information only.
Skill level: Maintenance Technician.
PROCEDURE
- Stick the label containing only the serial number information on the outer-left surface of the glove box. See Fig 2 .
- Stick the remaining two labels on the Anti-Theft Radio Identification Card and on the vehicle's service records.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.