Engine Coolant Temperature (ECT) Sensor

1998 Acura 3.5RL Special EditionSECTION Engine Coolant Temperature (ECT) Sensor
WARNING: This page is about a different car, the 1998 Acura 2.5TL. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Remove climate control unit and disconnect 20-pin connector. Disconnect ECT sensor connector. Check for continuity in Red/White wire between climate control unit connector and ECT sensor connector. If continuity does not exist, repair open Red/White wire between climate control unit and ECT sensor.
  2. If continuity exists, check for loose wires or poor connections at climate control unit 20-pin connector and ECT sensor connector. If connections are okay, substitute known-good climate control unit and recheck. If symptom goes away with known-good climate control unit, replace original climate control unit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.