Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (A/C-HEATER SYSTEM)SELF-DIAGNOSTICSCODE B: OUTSIDE AIR TEMPERATURE SENSOR
1998 Acura 3.5RL Special Edition
Code B: Outside Air Temperature Sensor
1998 Acura 3.5RL Special EditionSECTION Code B: Outside Air Temperature Sensor
WARNING: This page is about a different car, the 1998 Acura 3.0CL and 1998 Acura 2.3CL. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
To avoid damage to sensor, use an ohmmeter with a measuring current of one milliamp or less.
- Remove outside air temperature sensor. See OUTSIDE AIR TEMPERATURE SENSOR R & I. Measure resistance across sensor terminals. See OUTSIDE AIR TEMPERATURE SENSOR RESISTANCE table under TESTING. If resistance is not as specified, replace sensor.
- If resistance is within specifications, remove stereo unit and disconnect climate control 20-pin connector. Check for continuity between ground and terminal No. 15 (Brown/White wire) of climate control 20-pin connector. See Figure . If continuity exists, repair shorted Brown/White wire between climate control unit and outside air temperature sensor.
- If continuity does not exist, check for continuity between climate control unit 20-pin connector terminal No. 15 and outside air temperature sensor Brown/White wire terminal. If continuity does not exist, repair open Brown/White wire between climate control unit and outside air temperature sensor.
- If continuity exists, check for continuity between climate control unit 20-pin connector terminal No. 12 (Yellow/Green wire) and outside air temperature sensor Yellow/Green wire terminal. If continuity does not exist, repair open Yellow/Green wire between climate control unit and outside air temperature sensor.
- If continuity exists, check for loose wires or poor connections at climate control unit 20-pin connector and outside air temperature sensor connector. If connections are okay, substitute known-good climate control unit and recheck. If symptom does not exist after substituting known-good climate control unit, replace original climate control unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.