Removal & Installation (Integra)

1998 Acura 3.5RL Special EditionSECTION Removal & Installation (Integra)
  1. Disconnect negative battery cable. On hatchback models, fold seat-backs forward. Remove clips securing trunk mat to seat-backs and remove trunk mat. Remove clip pin on both sides of seat. See Fig 1. Slide seat-backs outward and remove seat-backs from pivot bracket. See Fig 1. Remove bolts located behind center of seat cushion. Disconnect seat cushion securing hooks and seat cushion.
  2. On Sedan models, fold seat-backs forward. Remove clips securing trunk mat to seat-backs. Disconnect hook located at front center of seat-back. See Fig 2. Remove remove trunk mat. Remove rear seat pivot bracket bolts. Remove bolts located behind center of seat cushion. See Fig 2. On all models, remove access panel. Disconnect fuel pump. Remove fuel pump nuts and pump. To install reverse removal procedure.
    Fig 1: Removing Rear Seat (Integra - Hatchback)
    G98A04630Courtesy of AMERICAN HONDA MOTOR CO., INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.