Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSISELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORSWITCHES
1998 Acura 3.5RL Special Edition
Electrical Component Locator: Switches
1998 Acura 3.5RL Special EditionSECTION Switches
SWITCHES
| Component | Component Location |
|---|---|
| A/C Pressure Switch | On front of vehicle, behind grille, on A/C line. |
| A/T Gear Position Switch | On underside of vehicle, left side of transmission. See Figure . |
| Brake Fluid Level Switch | On left rear of engine compartment, in brake fluid reservoir. |
| Brake Switch | Behind dash, top of brake pedal support. |
| Door Switches (Front) (2) | In respective "B" pillar. |
| Door Switches (Rear) (2) | In respective rear quarter panel. |
| Driver's Seat Belt Switch | In driver's seat belt buckle. |
| Engine Oil Pressure Switch | On lower center front of engine, above oil filter. |
| Hood Switch | At hood latch assembly. |
| Limit Switch 1 (Moon Roof) | On center underside of roof, above headliner. |
| Limit Switch 2 (Moon Roof) | On center underside of roof, above headliner. |
| Limit Switch 3 (Moon Roof) | On center underside of roof, above headliner. |
| Limit Switch 4 (Moon Roof) | On center underside of roof, above headliner. |
| Park Brake Switch | At left kick panel, at park brake lever. |
| Parking Pin Switch | Below center console, at base of gear selector. |
| Passenger's Seat Belt Switch (Front) | In front passenger's seat belt buckle. |
| Power Steering Pressure (PSP) Switch | On lower right front of engine compartment, on power steering line. See Figure . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.