Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSISELECTRICALCHARGING SYSTEMSGENERATORS & REGULATORSBENCH TESTINGROTOR SLIP RING
1998 Acura 3.5RL Special Edition
Rotor Slip Ring
1998 Acura 3.5RL Special EditionSECTION Rotor Slip Ring
- Check the resistance between the slip rings. There should be 2.9 ohms. If resistance meets the specification, go to next step. If resistance does not meet the specification, replace the alternator.
- Check that there is no continuity between the slip rings and the rotor or rotor shaft. See Fig 1.
- If the rotor fails either continuity check, replace the alternator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.