Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSDIAGNOSIS - M5DASYSTEM TESTINGA/T GEAR POSITION INDICATOR
1998 Acura 3.5RL Special Edition
A/T Gear Position Indicator
1998 Acura 3.5RL Special EditionSECTION A/T Gear Position Indicator
- Turn ignition off. Remove instrument panel gauge assembly from instrument panel. Disconnect 22-pin and 30-pin harness connectors from rear of instrument panel gauge assembly.
- Inspect and repair as necessary any loose, corroded or bent terminals. Check for voltage and continuity at harness connectors as specified. See Fig 1 . Repair as necessary. If all tests are okay and A/T gear position indicator is defective, replace printed circuit board.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.