Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION SHIFT INTERLOCK SYSTEMSCOMPONENT TESTINGPARKING PIN SWITCHPRELUDE
1998 Acura 3.5RL Special Edition
Parking Pin Switch: Prelude
1998 Acura 3.5RL Special EditionSECTION Prelude
- Turn ignition off. Remove center console. Disconnect mode switch 8-pin harness connector. Move shift lever in "P" position. Continuity should exist between mode switch harness connector terminals No. 3 (Black/White wire) and No. 8 (White/Black wire). Move shift lever out of "P" position. Continuity should not exist.
- If continuity is not as specified, replace faulty A/T gear position/mode/pin switch assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.