Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION OVERHAUL - M5DATRANSAXLE SPECIFICATIONS
1998 Acura 3.5RL Special Edition
Transaxle Specifications
1998 Acura 3.5RL Special EditionSECTION Transaxle Specifications
TRANSAXLE SPECIFICATIONS
| Application | In. (mm) | |||
|---|---|---|---|---|
| Clutch Clearance | ||||
| Reverse Clutch | .030-.037 (.75-.95) | |||
| 1st Clutch | .026-.033 (.65-.85) | |||
| 1st-Hold Clutch | .028-.035 (.70-.90) | |||
| 2nd & 3rd Clutches | .024-.031 (.60-.80) | |||
| 4th Clutch | .020-.028 (.50-.70) | |||
| Differential Ring Gear Backlash | .002-.006 (.06-.14) | |||
| Gear Clearances | ||||
| Countershaft 2nd Gear | .002-.005 (.05-.13) | |||
| Countershaft 4th Gear | 0-.003 (0-.08) | |||
| Mainshaft 4th Gear | .001-.007 (.03-.18) | |||
| Oil Pump Side Clearances | ||||
| Oil Pump Drive Gear | .0083-.0104 (.210-.265) | |||
| Oil Pump Driven Gear | .0028-.0049 (.070-.125) | |||
| Oil Pump Thrust Clearance | ||||
| Standard | .001-.002 (.03-.05) | |||
| Wear Limit | .0028 (.070) | |||
| Pinion Gear Backlash | .002-.006 (.05-.15) | |||
| INCH Lbs. (N.m) | ||||
| Secondary Gear Bearing Preload (1) | 31-40 (3.5-4.5) | |||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.