Hard To Start

1998 Acura 3.5RL Special EditionSECTION Hard To Start
  • Check fuel pressure. See BASIC TESTING article.
  • Check ignition system. See BASIC TESTING article.
  • Check MAP or MAF sensor (as equipped). See DTC P0101, P0106 or P0107 in TESTS W/CODES articles below:
  • For Integra, see TESTS W/CODES article.
  • For 2.3CL, see TESTS W/CODES article.
  • For 2.5CL, see TESTS W/CODES article.
  • For 3.0CL, see TESTS W/CODES article.
  • For 3.2TL, see TESTS W/CODES article.
  • For 3.5RL, see TESTS W/CODES article.
  • Check air cleaner.
  • Check BARO sensor. See DTC P1106, P1107 or P1108 in TESTS W/CODES articles below:
  • For Integra, see TESTS W/CODES article.
  • For 2.3CL, see TESTS W/CODES article.
  • For 2.5CL, see TESTS W/CODES article.
  • For 3.0CL, see TESTS W/CODES article.
  • For 3.2TL, see TESTS W/CODES article.
  • For 3.5RL, see TESTS W/CODES article.
  • Check EVAP control system.
  • Check for contaminated fuel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.