Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS - REMOVE/INSTALL/OVERHAULFUEL SYSTEMFUEL LINESQUICK-CONNECT FITTINGS
1998 Acura 3.5RL Special Edition
Quick-Connect Fittings
1998 Acura 3.5RL Special EditionSECTION Quick-Connect Fittings
- Relieve fuel pressure. Check quick-connect fittings for dirt and clean if necessary. Grasp connector with one hand. With other hand, squeeze retainer tabs inward. See Fig 1. Pull fuel lines apart and cover disconnected connector and pipe end. If quick-connect fuel line surface (located at fuel pump) is rusty or damaged, replace fuel pump of fuel feed pipe.
- Install NEW retainer if replacing fuel pump, replacing fuel feed pipe, retainer has been removed from pipe or is damaged. See Fig 2. Ensure a clicking sound is heard when reconnecting fittings. If fittings are difficult to reconnect, place a small amount of clean engine oil on pipe end.
- Ensure fittings are connected visually and by pulling connector. Pressurize fuel system by turning on ignition with engine off for 2 seconds. Repeat fuel pressurizing procedure 3 times. Check for fuel leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.