Right Mirror Inoperative (Integra)

1998 Acura 3.5RL Special EditionSECTION Right Mirror Inoperative (Integra)
  1. Connect a jumper wire between power mirror switch connector terminal "I" (Black/Yellow wire) and terminal "F" (Blue/White wire). See Fig 1. Connect a jumper wire between terminal "E" (Yellow/White wire) and ground. Right mirror should tilt down. If mirror does not tilt down, check for open in Yellow/White wire. If wire is okay, go to next step.
  2. Move jumper wire from terminal "E" (Yellow/White wire) to terminal "C" (Blue/Black wire). Right mirror should swing left. If mirror does not swing left, check for open in Blue/Black wire. If wire is okay, check right mirror motor. See POWER MIRROR MOTOR TESTΒ  under COMPONENT TESTS. If mirror does not tilt down and does not swing left, check for open in Blue/White wire. If mirror operates properly, check power mirror switch. See POWER MIRROR SWITCH TESTΒ  under COMPONENT TESTS.
Fig 1: Power Mirror Switch Connector Terminals (Integra)
G96G06712Courtesy of AMERICAN HONDA MOTOR CO., INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.