Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Right Mirror Inoperative (2.3CL & 3.0CL)
Connect a jumper wire between 10-pin connector terminal No. 9 (Yellow/Black wire) and terminal No. 6 (Yellow/White wire). See Fig 1. Connect jumper wire between 10-pin connector terminal No. 5 (Blue/White wire) and ground. Turn ignition on. Right mirror should tilt down. If mirror does not tilt down, check for open in Blue/White wire. If mirror does not tilt down or swing left, check for open in Yellow/Black wire. If wires are okay, check mirror switch. See POWER MIRROR SWITCH TEST under COMPONENT TESTS.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.