Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19983.5RL SPECIAL EDITIONREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESMULTIPLEX CONTROL SYSTEMSSYSTEM TESTSDIAGNOSTIC TESTSTEST 1
1998 Acura 3.5RL Special Edition
Test 1
1998 Acura 3.5RL Special EditionSECTION Test 1
- Ensure ignition is off. Check continuity in communication line (Brown/Yellow wire) between door multiplex control unit Blue 20-pin connector terminal No. 15 and driver's multiplex control unit Gray 26-pin connector terminal B23. If continuity does not exist, check for open in Brown/Yellow wire. If continuity exists, go to next step.
- Turn ignition on. Using a voltmeter, check communication line voltage at door multiplex control unit Blue 20-pin connector terminal No. 15 (Brown/Yellow wire). Voltage should read 2.4-4.2 volts. If voltage is as specified, replace door multiplex control unit with a known-good unit and retest system. If voltage is not as specified, go to next step.
- If voltage is more than 4.2 volts, check for short in Brown/Yellow wire and for poor connection or faulty circuit at receiver unit. If voltage is less than 2.4 volts, check for short to ground and for poor connection or faulty circuit at transmitter unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.