Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1997INTEGRA GS-R, 2D COUPEREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSAIR BAG RESTRAINT SYSTEMDISPOSAL PROCEDURESAIR BAG DEPLOYMENTOFF-VEHICLE
1997 Acura Integra GS-R, 2D Coupe
Air Bag Deployment: Off-Vehicle
1997 Acura Integra GS-R, 2D CoupeSECTION Off-Vehicle
- Before proceeding, read service precautions. See SERVICE PRECAUTIONS . Position air bag assembly face up, outdoors on flat ground and at least 30 feet from people or obstacles.
- Ensure proper operation of Deployment Tool (07HAZ-SG00400) by connecting a 12-volt battery per instructions supplied with tool. Press operation switch. If Green light on tool comes on, tool is okay. If Red light comes on, tool is faulty. Disconnect 12-volt battery from tool.
- Remove short connector from air bag connector. Cut off air bag connector, and strip back 1" of insulation from wire ends. Connect deployment tool's Yellow alligator clips to uninsulated wire ends. See Fig 1 . Place tool about 30 feet away from air bag. Connect 12-volt battery to deployment tool.
- If Red light on deployment tool comes on, go to next step. If Green light on deployment tool comes on, ignitor circuit is faulty. Air bag will not deploy. Contact manufacturer for disposal instructions.
- Push tool's deployment switch, being prepared for rapid inflation of air bag and loud noise. If air bag deploys, dispose of complete air bag assembly. Place it in a sturdy plastic bag and seal it securely. If air bag does not deploy, ignitor circuit is faulty. See DAMAGED AIR BAG SPECIAL PROCEDURE under DISPOSAL PROCEDURES. Contact manufacturer for disposal instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.