Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA19972.2CL STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSREMOVAL & INSTALLATION - A/TTORQUE SPECIFICATIONSINTEGRA
1997 Acura 2.2CL Standard
Torque Specifications: INTEGRA
1997 Acura 2.2CL StandardSECTION INTEGRA
TORQUE SPECIFICATIONS (INTEGRA)
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Ball Joint Nut | 36-44 (49-59) | |
| Center Crossmember Bolt | 33 (45) | |
| Drain Plug | 36 (49) | |
| Drive Plate-To-Crankshaft Bolt | 55 (75) | |
| Engine Stiffener Bolt | ||
| 8 mm | 18 (24) | |
| 10 mm | 32 (43) | |
| Exhaust Header Pipe Nut | 40 (54) | |
| Exhaust Pipe Bracket Bolt | 16 (22) | |
| Front Engine Mount Bolt | 48 (65) | |
| Intermediate Shaft Mount Bolt | 29 (39) | |
| Lower Plate Bolt | 29 (39) | |
| Rear Engine Mount Bolt | 87 (118) | |
| Rear Transaxle Mount Bolt | 44 (60) | |
| Rear Transaxle Mount Bracket Bolt | 28 (38) | |
| Shift Cable Cover Bolt | 16 (22) | |
| Starter-To-Housing Bolt | 33 (45) | |
| Strut Damper Lock Nut | 47 (64) | |
| Transaxle Housing-To-Engine Bolt | 47 (64) | |
| INCH Lbs. (N.m) | ||
| Flywheel Inspection Cover Bolt | 106 (12) | |
| Shift Cable Housing Bolt | 89 (10) | |
| Torque Converter Bolt | 106 (12) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.