Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Mirror Switch Test
Remove power mirror switch. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Using an ohmmeter, check continuity between specified switch terminals. See Fig 1 , Figure or Figure . See appropriate POWER MIRROR SWITCH CONTINUITY TEST table. If switch does not test as specified, replace faulty power mirror switch.
| Switch Position | Continuity Between Terminals | |
|---|---|---|
| Right Mirror | ||
| Off | A3, A5, A6 & A10 | |
| Up | A5 & A9; A3, A6 & A10 | |
| Down | A3, A6 & A9; A5 & A10 | |
| Left | A5, A6 & A9; A3 & A10 | |
| Right | A3 & A9; A5, A6 & A10 | |
| Left Mirror | ||
| Off | A4, A5, A7 & A10 | |
| Up | A5 & A9; A4, A7 & A10 | |
| Down | A4, A7 & A9; A5 & A10 | |
| Left | A5, A7 & A9; A4 & A10 | |
| Right | A4 & A9; A5, A7 & A10 | |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.