1997 Acura 2.2CL AutomaticFACTORY OEM SERVICE PROCEDURE

Abs Modulator Function Test

NOTE: This test ensures basic brake system operates normally when ABS modulator unit high-pressure side is low.
  1. Relieve system pressure. See RELIEVING ACCUMULATOR/LINE PRESSUREΒ  . Raise and support vehicle. Firmly depress brake pedal. If wheels cannot be rotated, go to next step. If wheels can be rotated, replace ABS modulator unit.
  2. Start engine to operate ABS pump motor. Keep brake fluid reservoir full. If brake fluid reservoir empties, bleed high-pressure brake fluid. See ACCUMULATORΒ  , MODULATOR & ABS PUMP (POWER UNIT) BLEEDING. If ABS pump motor operates for approximately 40 seconds, ABS indicator light will come on and ABS pump motor will stop. Turn engine off and restart engine to operate ABS pump motor again.
  3. If ABS indicator light comes on, remove ABS B2 fuse (15-amp) for at least 3 seconds to erase DTC after servicing. When ABS pump motor stops, refill brake fluid reservoir. Verify ABS indicator light stays off.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.