Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1996INTEGRA L4-1797CC 1.8L DOHC (VTEC)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSTORQUE AND SEQUENCEENGINE ASSEMBLY
1996 Acura Integra L4-1797cc 1.8L DOHC (VTEC)
Engine Assembly
1996 Acura Integra L4-1797cc 1.8L DOHC (VTEC)SECTION Engine Assembly
Intake:
Exhaust Manifold:
Upper Engine:
Cam Holder Torque/Sequence:
Head Bolt Torque Sequence:
Tighten head bolts, in sequence, in two steps:
1st step: Tighten to 30 N.m (3.0 kg-m, 22 lb.ft)
2nd step: Tighten to 85 N.m (8.7 kg-m, 63 lb.ft)
Water Pump:
Timing Components:
Lower Engine:
Main Bearing Torque/Sequence:
Engine Lubrication:
Flywheel (M/T) Torque:
Drive Plate (A/T) Torque/Sequence:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.