SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1996INTEGRA L4-1797CC 1.8L DOHC (VTEC)REPAIR AND DIAGNOSISSERVICE PRECAUTIONSVEHICLE DAMAGE WARNINGSLIFT AND SUPPORT POINTSLIFT AND SAFETY STANDS
1996 Acura Integra L4-1797cc 1.8L DOHC (VTEC)

Lift and Safety Stands

1996 Acura Integra L4-1797cc 1.8L DOHC (VTEC)SECTION Lift and Safety Stands




WARNING
- When heavy rear components such as suspension, fuel tank, spare tire and hatch are to be removed, place additional weight in the luggage area before hoisting. When substantial weight is removed from the rear of the car, the center of gravity may change and can cause the car to tip forward on the hoist.

NOTE:
- Since each tire/wheel assembly weighs approximately 14 kg (30 lbs), placing the front wheels in trunk can assist with the weight distribution.

1. Place the lift blocks as shown.
2. Raise the hoist a few inches (centimeters), and rock the car to be sure it is firmly supported.
3. Raise the hoist to full height, and inspect the lift points for solid support.

NOTE:
- Use the same support points to support the car on safety stands.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.