Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1996INTEGRA L4-1797CC 1.8L DOHC (VTEC)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMDISTRIBUTORSERVICE AND REPAIRREASSEMBLY
1996 Acura Integra L4-1797cc 1.8L DOHC (VTEC)
Reassembly
1996 Acura Integra L4-1797cc 1.8L DOHC (VTEC)SECTION Reassembly
Distributor:
DISTRIBUTOR / REASSEMBLY
1. When reassembling the distributor, install the rotor on the shaft so that it faces in the direction shown (toward the No. 1 cylinder).
2. Align the index mark on the distributor ignition (DI) housing with the index mark on the end of the shaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.