Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)FACTORY OEM SERVICE PROCEDURE
Toe-In
Ensure tires are properly inflated prior to checking or adjusting toe-in.
1. Raise front of vehicle and position turning radius gauges under front wheels, then lower vehicle.
2. Center steering wheel spokes and measure difference in toe measurements with wheels in the straight-ahead position.
3. If toe-in does not meet specifications, proceed as follows:
a. Loosen tie rod locknuts and turn both tie rods, Fig. 6, in the same direction until front wheels are in the straight-ahead position.
b. Turn both tie rods an equal amount until toe-in meets specifications, then tighten tie rod locknuts. Ensure tie rod boots are not deformed after adjustment.
Fig. 6 Front Toe-in Adjustment:
1. Raise front of vehicle and position turning radius gauges under front wheels, then lower vehicle.
2. Center steering wheel spokes and measure difference in toe measurements with wheels in the straight-ahead position.
3. If toe-in does not meet specifications, proceed as follows:
a. Loosen tie rod locknuts and turn both tie rods, Fig. 6, in the same direction until front wheels are in the straight-ahead position.
b. Turn both tie rods an equal amount until toe-in meets specifications, then tighten tie rod locknuts. Ensure tie rod boots are not deformed after adjustment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.