Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1994INTEGRA (GS-R) L4-1797CC 1.8L DOHC (VTEC)REPAIR AND DIAGNOSISMAINTENANCEFLUIDSFLUID - M/TSERVICE AND REPAIR
1994 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)
Fluid - M/T: Service and Repair
1994 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)SECTION Service and Repair
NOTE: Check the transmission oil with the engine OFF the car on level ground.
1. Remove the oil filler plug, then check the level and condition of the oil.
2. The oil level must be up to the filler hole. If it is below the hole, add oil until it runs out, then reinstall the oil filler plug.
3. If the transmission oil is dirty, remove the drain plug and drain the oil.
4. Reinstall the drain plug with a new washer, and refill the transmission oil to the proper level.
NOTE: The drain plug washer should be replaced at every oil change.
5. Reinstall the oil filler plug with a new washer.
- Oil Capacity:
2.2 l (2.3 US.qt) at oil change.
2.3 l (2.4 US.qt) at overhaul.
- Always use genuine Honda Manual Transmission Fluid (MTF). If it is not available, you may use an API service SG or SH grade motor oil with a viscosity of SAE 10 W-30 or 10 W-40 as a temporary replacement. Motor oil can cause increased transmission wear and higher shifting effort, so you should have the transmission drained and refilled with Honda MTF as soon as possible.
1. Remove the oil filler plug, then check the level and condition of the oil.
2. The oil level must be up to the filler hole. If it is below the hole, add oil until it runs out, then reinstall the oil filler plug.
3. If the transmission oil is dirty, remove the drain plug and drain the oil.
4. Reinstall the drain plug with a new washer, and refill the transmission oil to the proper level.
NOTE: The drain plug washer should be replaced at every oil change.
5. Reinstall the oil filler plug with a new washer.
- Oil Capacity:
2.2 l (2.3 US.qt) at oil change.
2.3 l (2.4 US.qt) at overhaul.
- Always use genuine Honda Manual Transmission Fluid (MTF). If it is not available, you may use an API service SG or SH grade motor oil with a viscosity of SAE 10 W-30 or 10 W-40 as a temporary replacement. Motor oil can cause increased transmission wear and higher shifting effort, so you should have the transmission drained and refilled with Honda MTF as soon as possible.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.