Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1994INTEGRA (GS-R) L4-1797CC 1.8L DOHC (VTEC)REPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINETIMING COMPONENTSTIMING BELTLOCATIONS
1994 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)
Timing Belt: Locations
1994 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)SECTION Locations
Timing Belt
NOTE:
- Position crankshaft and pulley before installing belt.
- Mark the direction of rotation on the belt before removing.
- Replace the rubber seals if there is oil leakage between the cylinder head and cover.
- Do not use the middle cover and lower cover for storing removed items.
- Clean the middle cover and lower cover before installation.
NOTE: When installing a new crankshaft and/or new bolt:
(1) tighten the crankshaft pulley bolt to 196 N.m (20.0 kg.m, 145 lb.ft)
(2) loosen bolt
(3) retighten it to 177 N.m (18.0 kg.m, 130 lb.ft)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.