1993 Acura Legend Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
ABS Control Unit Behind right rear seat. See Figure .
Climate Control Unit In center of dash, integral of A/C control panel.
Cooling Fan Control Unit Under carpeting and cover, next to PCM. See Figure .
Cruise Control Unit Behind right side kick panel. See Figure .
Dash Light Brightness Control Unit Behind center of dash. See Figure .
Daytime Running Light (DRL) Control Unit (Canada) Behind dash, right of steering column. See Figure .
Ignition Control Module (ICM)
View of Relays On inner right fender panel, on strut tower. See Figure .
Engine Compartment On inner right fender panel, on strut tower. See Figure .
Integrated Control Unit Mounted behind passenger compartment fuse/relay block. See Figure .
Interlock Control Unit (A/T) Behind left side of dash. See Figure .
Keyless Entry Control Unit On left lower dash panel.
Lights-On Chime Module Above left side of steering column.
Powertrain Control Module (PCM)
Floor of Passenger Compartment Under carpeting and cover, in passenger's footwell. See Figure .
View of Ctrl Units & Modules Under carpeting and cover, in passenger's footwell. See Figure .
Power Door Lock Control Unit Behind left side of dash, to right of steering column. See Figure .
Power Window Control Unit Built-in to driver-side window control panel. See Figure .
Power Seat Control Unit Under driver's seat.
Radiator Fan Control Module Behind right kick panel. See Figure .
Seat Heater Control Unit Under passenger's seat.
Security Control Unit Behind left side of dash, to right of steering column. See Figure .
SRS Control Unit Under center console. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.