Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Acura Legend Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location | ||
|---|---|---|---|
| Fuse/Relay Block | |||
| Engine Compartment | On left inner fender panel, behind battery. See Figure . | ||
| Passenger Compartment | |||
| Bottom Driver's Side of Dash | Behind left kick panel. See Figure . | ||
| Top Driver's Side of Dash | Behind left kick panel. See Figure . | ||
| Underhood Relay Box | |||
| "A" | On left top radiator support, near battery. See Figure . | ||
| "B" | On right rear of engine compartment, near strut tower. See Figure . | ||
| Keyless Entry In-Line Fuse | Behind dash, left of steering column. | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
