1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Legend & Vigor

  1. Turn engine off. Turn ignition on. Ensure ANTI-LOCK warning light comes on. Start engine and check ANTI-LOCK warning light. If warning light goes out, no fault codes exist.
  2. If light remains on, turn engine off. Disconnect service check connector from connector cover located under glove box. See Fig 1 . Connect jumper wire between the two service check connector terminals.
  3. Turn ignition on, but DO NOT start engine. Record flashing frequency of ANTI-LOCK warning light.
  4. First flashing sequence indicates main code of DTC, and second number indicates sub code of DTC. See Figure . A one-second pause separates main and sub codes. Total of 3 DTC's can be set at one time. There is a 5-second pause between DTC's.
  5. To recheck DTC sequence, turn ignition off for a few seconds and then turn it back on. After codes are retrieved, go to appropriate test under TROUBLE CODESΒ  to diagnose system.
Fig 1: Identifying Service Check Connector
G98I10338
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.