Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Code 1, Pump Motor Overrun
- Bleed high-pressure fluid from maintenance bleeder using ABS "T" Wrench (07HAA-SG00100). See RELIEVING ACCUMULATOR/LINE PRESSURE under BLEEDING BRAKE SYSTEM. Disconnect pump motor relay connector, and remove relay. See Figure . Connect terminals No. 3 and 8 together for about 8 seconds using a jumper wire. See Fig 1 , Fig 2 and Figure .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.