Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Master Cylinder Push Rod
NOTE:
Check and adjust master cylinder push rod-to-piston clearance before installing master cylinder.
- Install Push Rod Adjustment Gauge (07JAG-SD40100). Ensure adjusting bolt is flush with end of master cylinder. See Fig 1 . Ensure gasket is in position when adjusting rod clearance.
- Remove push rod adjustment gauge from master cylinder, and install it on brake booster. Tighten mounting nuts to 11 ft. lbs. (15 N.m). Using engine or outside vacuum source, apply at least 20 in. Hg vacuum to brake booster.
- Using a feeler gauge, ensure clearance is 0-.016" (0-.41 mm) on Integra or 0-.008" (0-.20 mm) on Legend or Vigor. See Fig 2 . If clearance is incorrect, loosen star lock nut and turn adjuster in or out to adjust clearance. Hold clevis while adjusting.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.