Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSACURA1986LEGEND AUTOMATICREPAIR AND DIAGNOSISQUICK LOOKUPSTECHNICAL BULLETINSTECHNICAL SERVICE BULLETINSHVAC CONTROL SYSTEMSDEBRIS IN VENTS GET IN BLOWER MOTOR - INSTALL SCREEN (87-007)
1986 Acura Legend Automatic
Debris In Vents Get In Blower Motor - Install Screen (87-007)
1986 Acura Legend AutomaticSECTION Debris In Vents Get In Blower Motor - Install Screen (87-007)
Publication date: 1987-04-01
Reference number: 87-007
DEBRIS IN VENTS GET IN BLOWER MOTOR - INSTALL SCREEN
Reference number: 87-007
DEBRIS IN VENTS GET IN BLOWER MOTOR - INSTALL SCREEN
TECHNICAL SERVICE BULLETIN
Reference Number(s): 87-007
AIR INTAKE SCREENS
Model(s): 1985-86 Acura Models
Group: Maintenance/PDI
Bulletin No.: 87-007
Date: April, 1987
NOTE:
This bulletin supersedes Service Bulletin 87-007, dated March 30, 1987.
PROBLEM
Debris In Blower Motor
CORRECTIVE ACTION
Install wire mesh screens over the intake vents in the cowl area as described below:
LEGEND
- Remove the windshield wiper arms rubber hood seal and top cowl garnish.
- Cut 1/4 inch wire mesh screen using the dimensions given in Fig 1 and Fig 2 .
- Lay the large screen (A) over the center air intake vents, and gently push into place. See Fig 3 .
- Fit the small screen (B) over the left side air intake vent (and wiper pivot cover). See Fig 3 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.