B1192

Factory Manual References

Factory service manual diagnostic procedure for 2010 acura zdx

A L L Diagnostic Trouble Codes ( DTC )

B1192




DTC Troubleshooting: B1192

DTC B1192:

Gauge Control Module Lost Communication With the Battery Sensor (URAT LINE)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A

1. Clear the DTCs with the HDS.

2. Wait for at least 15 seconds.

3. Check for DTCs with the HDS.

Is DTC B1192 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, the battery sensor is OK at this time.�

4. Check the No. 11 (7.5 A) fuse in the auxiliary under-hood fuse/relay box.

Is the fuse OK?

YES -

Go to step 5.

NO -

Replace the fuse, and recheck the system. If the fuse is blown again, repair a short in the wire.�

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Disconnect the battery sensor 2P connector.

7. Measure the voltage between battery sensor 2P connector terminal No. 2 and body ground.

Factory service manual diagram




Is there battery voltage?

YES -

Go to step 8.

NO -

Repair an open in the wire between the auxiliary under-hood fuse/relay box and the battery sensor.�

8. Disconnect gauge control module connector B (20P).

9. Measure the voltage between battery sensor 2P connector terminal No. 1 and body ground.

Factory service manual diagram




Is there voltage?

YES -

Repair a short to power in the wire between the gauge control module and battery sensor.�

NO -

Go to step 10.

10. Check for continuity between battery sensor 2P connector terminal No. 1 and body ground.

Factory service manual diagram




Is there continuity?

YES -

Repair a short to ground in the wire between the battery sensor and the gauge control module.�

NO -

Go to step 11.

11. Check for continuity between battery sensor 2P connector terminal No. 1 and gauge control module connector B (20P) terminal No. 7.

Factory service manual diagram




Is there continuity?

YES -

Substitute a known-good battery sensor, and recheck. If the DTC returns, replace gauge control module Service and Repair.�

NO -

Repair an open in the wire between the battery sensor and the gauge control module.�

Supporting Diagrams & Locations

Reference material from the factory manual for this diagnostic procedure.

Diagram

A/C Leak Detection (B07-025)

Diagram

Air Conditioning

Diagram

Anti-Lock Brakes

Diagram

Anti-Theft

Diagram

Body Control Modules

Diagram

Computer Data Lines

Location

CHRYSLER Group LLC

Location

CHRYSLER Group LLC

Location

ACURA

Location

AUDI

Fuse/Relay

CHRYSLER Group LLC

Fuse/Relay

AUDI

Fuse/Relay

BMW

Fuse/Relay

CHRYSLER Group LLC

Related Procedures

Procedure

Air Bags (10V145000)

Procedure

A/C Refrigerant (Compressor) Oil Guide (BJA34004)

Procedure

A/C Refrigerant And Oil Type Guide (BJA1330)

Procedure

A/C Refrigerant Type Guide (BJA11220)

Procedure

A/C Refrigerant Types Guide (BJA09917 VERSION 2)

Procedure

Drive Belt Squeaks (10-035)