A and AUTO
DTC Troubleshooting: B1225 or Indicator A and AUTO
DTC B1225 or DTC indicator A and AUTO: An Open in the In-car Temperature Sensor Circuit
1. Clear the DTC with the HDS.
2. Turn the ignition switch to LOCK (0), and then to ON (II).
3. Do the self-diagnostic with the HDS Initial Inspection and Diagnostic Overview or climate control unit. Initial Inspection and Diagnostic Overview
4. Check for DTCs.
Is DTC B1225 or A and AUTO indicated?
YES - Go to step 5.
NO - Intermittent failure. Check for loose wires or poor connections on the in-car temperature sensor circuit.
5. Turn the ignition switch to LOCK (0).
6. Remove the in-car temperature sensor, Service and Repair and test it. In-car Temperature Sensor Test
Is the in-car temperature sensor OK?
YES - Go to step 7.
NO - Replace the in-car temperature sensor.
7. Disconnect climate control unit connectors A (28P) and B (12P).
8. Check for continuity between climate control unit connector A (28P) terminal No. 26 and in-car temperature sensor 2P connector terminal No. 1.
Is there continuity?
YES - Go to step 9.
NO - Repair an open in the wire between the climate control unit and the in-car temperature sensor.
9. Check for continuity between climate control unit connector B (12P) terminal No. 10 and in-car temperature sensor 2P connector terminal No. 2.
Is there continuity?
YES - Check for loose wires or poor connections at climate control unit connectors A (28P), B (12P), and at the in-car temperature sensor 2P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit.
NO - Repair an open in the wire between the climate control unit and the in-car temperature sensor.
