B1242

DTC Troubleshooting: B1242 (E and MODE)

DTC B1242 or DTC indicator E and MODE:

An Open or Short in the Passenger's Mode Control Motor Circuit

1. Clear the DTC with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II), or press the engine start/stop button to select the OFF mode, and then the ON mode.

3. Do the Self-diagnostic Function with the HDS Initial Inspection and Diagnostic Overview or with the climate control unit Initial Inspection and Diagnostic Overview.

4. Check for DTCs.

Is DTC B1242 or E and MODE indicated?

YES -

Go to step 5.

NO -

Intermittent failure. Check for loose wires or poor connections on the passenger's mode control motor circuit.�

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Test the passenger's mode control motor Passenger's Mode Control Motor Test.

Is the passenger's mode control motor OK?

YES -

Go to step 7.

NO -

Replace the passenger's mode control motor Passenger's Mode Control Motor Replacement.�

7. Disconnect the passenger's mode control motor 7P connector.

8. Disconnect climate control unit connectors A (32P) and C (20P).

9. Check for continuity between the following terminals of climate control unit connector A (32P), C (20P) and the passenger's mode control motor 7P connector.

















Is there continuity?

YES -

Go to step 10.

NO -

Repair an open in the wire(s) between the climate control unit and the passenger's mode control motor.�

10. Check for continuity between body ground and climate control unit connector A (32P) terminals No. 17, 18, 19, and 20 individually.





Is there continuity?

YES -

Repair a short to body ground in the wire(s) between the climate control unit and the passenger's mode control motor.�

NO -

Go to step 11.

11. Check for continuity between climate control unit connector A (32P) terminals as follows.









Is there continuity between any of the terminals?

YES -

Repair a short in the wires.�

NO -

Go to step 12.

12. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and measure the voltage between the same terminals and body ground.





Is there any voltage?

YES -

Repair a short to power in the wire(s) between the climate control unit and the passenger's mode control motor. This short may also damage the climate control unit. Repair a short to power before replacing the climate control unit.�

NO -

Check for loose wires or poor connections at climate control unit connector A (32P) and at the passenger's mode control motor 7P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit Climate Control Unit Removal/Installation.�