B1152

Factory Manual References

Factory service manual diagnostic procedure for 2010 acura tl

A L L Diagnostic Trouble Codes ( DTC )

B1152




DTC Troubleshooting: B1152

DTC B1152:

Gauge Control Module (EEPROM) Error

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II), or press the engine start/stop button to select the OFF mode and then the ON mode.

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC B1152 indicated?

YES -

Replace the gauge control module Service and Repair.οΏ½

NO -

Intermittent failure, the system is OK at this time.οΏ½

A L L Diagnostic Trouble Codes ( DTC )

Supporting Diagrams & Locations

Reference material from the factory manual for this diagnostic procedure.

Diagram

A/C Leak Detection (B07-025)

Diagram

A/C Leak Detection (B07-025)

Diagram

A/C Leak Detection (B07-025)

Location

ACURA

Location

AUDI

Location

ACURA Torque Converter Clutch Shudder Snap Shot Evaluation Job Aid (JA4659)

Location

Automatic Transmission In-Warranty Exchange Program (90-009)

Fuse/Relay

B1036

Fuse/Relay

B1077

Fuse/Relay

B10A2

Fuse/Relay

B10CF

Related Procedures

Procedure

A/C Refrigerant (Compressor) Oil Guide (BJA34004)

Procedure

A/C Refrigerant And Oil Type Guide (BJA1330)

Procedure

A/C Refrigerant Type Guide (BJA11220)

Procedure

A/C Refrigerant Types Guide (BJA09917 VERSION 2)

Procedure

Always Enter Campaign Number On Proof Of Correction Certificate (B13010B)

Procedure

ACURA Recommended Materials (B99-015)

← Back to 2010 acura tlBrowse vehicle codesDIY Repair Guides