B1007

DTC Troubleshooting: B1000

DTC B1000: Communication Bus Line Error (BUS-OFF)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC B1000 indicated?
YES - Go to step 5.

NO - Intermittent failure, the communication bus line is OK at this time. Check for loose or poor connections, or worn/shorted wires. If the connections are good, check the battery condition Testing and Inspection and the charging system.


5. Check for DTCs with the HDS.

Are DTCs B1005, B1007, B1008, B1011, B1013, B1014, B1015, and B1016 also indicated?
YES - Go to step 6.

NO - Faulty MICU; replace the driver's under-dash fuse/relay box. Driver's Under-dash Fuse/Relay Box (MICU) Removal/Installation


6. Disconnect the appropriate connector at each control unit in the table one at a time. Clear the DTC and wait for at least 6 seconds, then recheck for DTCs after each unit is disconnected.





Is DTC B1000 indicated with each individual unit disconnected?
YES - Go to step 7.

NO - Replace the control unit that was disconnected and B1000 did not reset.


7. Disconnect all of the appropriate connectors for each of the units in the table.





8. Disconnect driver's under-dash fuse/relay box connectors X (39P), N (45P), J (30P), G (8P), D (17P), and T (6P).

9. Check for continuity between each of the driver's under-dash fuse/relay box terminals listed in the table below and body ground.





Is there continuity?
YES - Repair the short in the wire between the driver's under-dash fuse/relay box and affected control unit.

NO - Replace the driver's under-dash fuse/relay box. Driver's Under-dash Fuse/Relay Box (MICU) Removal/Installation

DTC Troubleshooting: B1007

DTC B1007: MICU Lost Communication With Combination Switch Control Unit (HLSW Message)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC B1007 indicated?
YES - Go to step 5.

NO - Intermittent failure, the system is OK at this time. Check for loose or poor connections between the MICU and combination switch control unit, if the connections are good, check the battery condition Testing and Inspection and the charging system.


5. Check for DTCs with the HDS.

Are DTCs B1062, B1155, and B2108 all indicated?
YES - Do the combination switch control unit input test. Combination Switch Control Unit Input Test

NO - Check for an open in the communication circuit between the MICU and the gauge control module. If the circuit is OK, replace the MICU Driver's Under-dash Fuse/Relay Box (MICU) Removal/Installation. If the circuit is bad, repair the open.