P0306

Factory Manual References

Factory service manual diagnostic procedure for 2009 audi a4

01 Mil On, Cold Start Misfire (Misfire DTCS P0300-P0306 In ECM) (2024632)

Publication date: 2010-12-20
Reference number: 2024632

01 MIL ON, COLD START MISFIRE (MISFIRE DTCS P0300-P0306 IN ECM)

01 MIL ON, COLD START MISFIRE (MISFIRE DTCS P0300-P0306 IN ECM)

TECHNICAL SERVICE BULLETIN

Reference Number(s): 2024632/3, Date of Issue:  December 20, 2010
AUDI: A4, A6

CONDITION

  • MIL on.
  • Misfire DTCs (P0300, P0301, P0302, P0303, P0304, P0305 or P0306) are stored in the ECM.
  • Freeze frame data indicates DTCs stored during cold start (engine coolant temperature between 18 - 36°C).

TECHNICAL BACKGROUND

Software update is needed.

PRODUCTION SOLUTION

New software in the 4F2 910 559 H Control Module (J623) addressed the condition.

SERVICE

  1. Follow all instructions in the attached TSB 2011732 00 Software Version Management (SVM), operating instructions.
  2. Update the ECM using the SVM action code as listed in the table below, if necessary.
  3. Perform a short test drive.
  4. Verify repair during cold start next morning via recording MVB 14 and 15 (ambient temperature between 50 - 80°F).

Tip:  Based on normal fuel quality variation under certain ambient conditions some single misfires may be recorded during cold start (catalytic converter heating phase). This will have no negative effect, no further investigation is needed.

SOFTWARE INFORMATION

Model Engine and/or Transmission Old Software Part Number Old Software Version New Software Part Number New Software Version (or higher) SVM Action Code
A6 MY08/09 3.2 V6 FSI 4F2 910559 H 0020 4F2 910559 H 0040 01A029
A6 MY07 3.2 V6 FSI 4F2 910559 C 0020 4F2910559C 0070
A4 (8E, 8H) 3.2 V6 FSI 8E1910559F 0060 8E1910559F 0070

WARRANTY

WARRANTY INFORMATION

Claim Type:  Use applicable claim type. If vehicle is outside any warranty, this Technical Service Bulletin is informational only.
Service Number:  2470
Damage Code:  0039
Labor Operations:  Check software levels, no update necessary 2470 01 99 20 TU
Check software levels, perform update 2470 25 99 60 TU
Diagnostic Time:  GFF - Checking and clearing fault codes included in existing labor operations No allowance 0 TU
Road test prior to service procedure 0121 0002 10 TU
Road test after service procedure 0121 0004 10 TU
Technical diagnosis at dealer's discretion
(Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details)
Claim Comment:  As per TSB #2024632/3

All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual.  Claims are subject to review or audit by Audi Warranty.

ADDITIONAL INFORMATION

All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.

ATTACHMENT

Fig 1: TSB 2011732 - Software Version Management (SVM), Operating Instructions - Page 1
G06506713

01 Mil On, Cold Start Misfire (Misfire DTCS P0300-P0306 In ECM) (2024632)

Publication date: 2010-12-20
Reference number: 2024632

01 MIL ON, COLD START MISFIRE (MISFIRE DTCS P0300-P0306 IN ECM)

01 MIL ON, COLD START MISFIRE (MISFIRE DTCS P0300-P0306 IN ECM)

TECHNICAL SERVICE BULLETIN

Reference Number(s): 2024632/3, Date of Issue:  December 20, 2010
AUDI: A4, A6

CONDITION

  • MIL on.
  • Misfire DTCs (P0300, P0301, P0302, P0303, P0304, P0305 or P0306) are stored in the ECM.
  • Freeze frame data indicates DTCs stored during cold start (engine coolant temperature between 18 - 36°C).

TECHNICAL BACKGROUND

Software update is needed.

PRODUCTION SOLUTION

New software in the 4F2 910 559 H Control Module (J623) addressed the condition.

SERVICE

  1. Follow all instructions in the attached TSB 2011732 00 Software Version Management (SVM), operating instructions.
  2. Update the ECM using the SVM action code as listed in the table below, if necessary.
  3. Perform a short test drive.
  4. Verify repair during cold start next morning via recording MVB 14 and 15 (ambient temperature between 50 - 80°F).

Tip:  Based on normal fuel quality variation under certain ambient conditions some single misfires may be recorded during cold start (catalytic converter heating phase). This will have no negative effect, no further investigation is needed.

SOFTWARE INFORMATION

Model Engine and/or Transmission Old Software Part Number Old Software Version New Software Part Number New Software Version (or higher) SVM Action Code
A6 MY08/09 3.2 V6 FSI 4F2 910559 H 0020 4F2 910559 H 0040 01A029
A6 MY07 3.2 V6 FSI 4F2 910559 C 0020 4F2910559C 0070
A4 (8E, 8H) 3.2 V6 FSI 8E1910559F 0060 8E1910559F 0070

WARRANTY

WARRANTY INFORMATION

Claim Type:  Use applicable claim type. If vehicle is outside any warranty, this Technical Service Bulletin is informational only.
Service Number:  2470
Damage Code:  0039
Labor Operations:  Check software levels, no update necessary 2470 01 99 20 TU
Check software levels, perform update 2470 25 99 60 TU
Diagnostic Time:  GFF - Checking and clearing fault codes included in existing labor operations No allowance 0 TU
Road test prior to service procedure 0121 0002 10 TU
Road test after service procedure 0121 0004 10 TU
Technical diagnosis at dealer's discretion
(Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details)
Claim Comment:  As per TSB #2024632/3

All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual.  Claims are subject to review or audit by Audi Warranty.

ADDITIONAL INFORMATION

All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.

ATTACHMENT

Fig 1: TSB 2011732 - Software Version Management (SVM), Operating Instructions - Page 1
G06506713

01 Mil On, Cold Start Misfire (Misfire DTCS P0300-P0306 In ECM) (2024632)

WARNING: This page is about the A4 Avant Quattro, which is a different variant/trim than selected.
Publication date: 2010-12-20
Reference number: 2024632

01 MIL ON, COLD START MISFIRE (MISFIRE DTCS P0300-P0306 IN ECM)

01 MIL ON, COLD START MISFIRE (MISFIRE DTCS P0300-P0306 IN ECM)

TECHNICAL SERVICE BULLETIN

Reference Number(s): 2024632/3, Date of Issue:  December 20, 2010
AUDI: A4, A6

CONDITION

  • MIL on.
  • Misfire DTCs (P0300, P0301, P0302, P0303, P0304, P0305 or P0306) are stored in the ECM.
  • Freeze frame data indicates DTCs stored during cold start (engine coolant temperature between 18 - 36°C).

TECHNICAL BACKGROUND

Software update is needed.

PRODUCTION SOLUTION

New software in the 4F2 910 559 H Control Module (J623) addressed the condition.

SERVICE

  1. Follow all instructions in the attached TSB 2011732 00 Software Version Management (SVM), operating instructions.
  2. Update the ECM using the SVM action code as listed in the table below, if necessary.
  3. Perform a short test drive.
  4. Verify repair during cold start next morning via recording MVB 14 and 15 (ambient temperature between 50 - 80°F).

Tip:  Based on normal fuel quality variation under certain ambient conditions some single misfires may be recorded during cold start (catalytic converter heating phase). This will have no negative effect, no further investigation is needed.

SOFTWARE INFORMATION

Model Engine and/or Transmission Old Software Part Number Old Software Version New Software Part Number New Software Version (or higher) SVM Action Code
A6 MY08/09 3.2 V6 FSI 4F2 910559 H 0020 4F2 910559 H 0040 01A029
A6 MY07 3.2 V6 FSI 4F2 910559 C 0020 4F2910559C 0070
A4 (8E, 8H) 3.2 V6 FSI 8E1910559F 0060 8E1910559F 0070

WARRANTY

WARRANTY INFORMATION

Claim Type:  Use applicable claim type. If vehicle is outside any warranty, this Technical Service Bulletin is informational only.
Service Number:  2470
Damage Code:  0039
Labor Operations:  Check software levels, no update necessary 2470 01 99 20 TU
Check software levels, perform update 2470 25 99 60 TU
Diagnostic Time:  GFF - Checking and clearing fault codes included in existing labor operations No allowance 0 TU
Road test prior to service procedure 0121 0002 10 TU
Road test after service procedure 0121 0004 10 TU
Technical diagnosis at dealer's discretion
(Refer to Section 2.2.1.2 and Audi Warranty Online for DADP allowance details)
Claim Comment:  As per TSB #2024632/3

All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual.  Claims are subject to review or audit by Audi Warranty.

ADDITIONAL INFORMATION

All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service manuals for the latest information.

ATTACHMENT

Fig 1: TSB 2011732 - Software Version Management (SVM), Operating Instructions - Page 1
G06506713

Supporting Diagrams & Locations

Reference material from the factory manual for this diagnostic procedure.

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Fuse/Relay

12 Volt Socket In The Rear Section Of The Center Console Does Not Work. (GROUP 97, NO. 11-25)

Fuse/Relay

12 Volt Socket In The Rear Section Of The Center Console Does Not Work. (GROUP 97, NO. 11-25)

Fuse/Relay

12 Volt Socket In The Rear Section Of The Center Console Does Not Work. (GROUP 97, NO. 11-25)

Fuse/Relay

12 Volt Socket In The Rear Section Of The Center Console Does Not Work. (GROUP 97, NO. 11-25)

← Back to 2009 audi a4General P0306 InfoDIY Repair Guides