B1152

DTC B1152: Gauge Control Module Internal Error (EEPROM) Error

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Wait for 6 seconds or more.
4. Check for DTCs with the HDS.

Is DTC B1152 indicated?

YES - Replace the gauge control module.

NO - Intermittent failure, the system is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition, and the charging system.