P1751

DTC 18159 / P1751





Notes on DTC 18159 / P1751:
^ Condition for DTC recognition: Battery voltage above 16 volts.
^ This DTC was also displayed, for example, when jump starting with a 24 volt battery.

DTC 18159 / P1751





Note for DTC 18159 / P1751:
^ Conditions for fault recognition: Battery voltage higher than 16 Volt.
^ Battery monitoring differentiates between four areas: (U = battery voltage) First U < 7 Volt => Transmission goes into mechanical backup with non-active control module; Second 7 Volt< U < 9 Volt=^Transmission range is held for about 2.5 sec., if U is then still in this range, the transmission goes into mechanical backup with non-active control module; Third 9 Volt < U < 16 Volt -> voltage is OK; Fourth U > 16 Volt => transmission goes into mechanical backup with non-active control module.

DTC 18159 / P1751





Note:
For DTC 18159 / P1751:

^ Requirement for malfunction recognition: Battery voltage larger than 16 Volts.

^ The battery monitoring differentiates four ranges: (U = Battery voltage) 1. U < 7 Volts transmission switches into emergency running mode; 2. 7 Volts < U < 9 Volts gear is held for approx. 2.5 seconds, if voltage is still in this range, the transmission shifts into emergency running mode; 3. 9 Volts < U < 16 Volts Voltage is OK; 4. U > 16 Volts transmission shifts into emergency running mode.