P0727

P0727

Factory Manual References

Factory service manual diagnostic procedure for 2005 audi allroad

01J, Constantly Variable Transmission (CVT)

DTC 17111 / P0727

Note on DTC 17111 / P0727:
^ In the event of an open circuit in the RPM lead, the substitute engine RPM signal is transmitted by the Engine Control Module (ECM) over the CAN bus circuit to the Transmission Control Module (TCM).

01J, Constantly Variable Transmission (CVT)

P0730

Note on DTC 17111 / P0727:
^ In the event of an open circuit in the RPM lead, the substitute engine RPM signal is transmitted by the Engine Control Module (ECM) over the CAN bus circuit to the Transmission Control Module (TCM).

01J, Constantly Variable Transmission (CVT)

DTC 17111 / P0727

Note on DTC 17111 / P0727:
^ In the event of an open circuit in the RPM lead, the substitute engine RPM signal is transmitted by the Engine Control Module (ECM) over the CAN bus circuit to the Transmission Control Module (TCM).

Supporting Diagrams & Locations

Reference material from the factory manual for this diagnostic procedure.

Diagram

2.7L Turbo

Diagram

4.2L

Diagram

2.7L Turbo

Diagram

4.2L

Diagram

2.7L Turbo

Diagram

4.2L

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Location

57 Vehicle Locking System, Diagnostic Information (GROUP 57, NO. 24-65)

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

← Back to 2005 audi allroad Browse vehicle codes DIY Repair Guides