P1704

Factory Manual References

Factory service manual diagnostic procedure for 2004 audi allroad

01J, Constantly Variable Transmission (CVT)



DTC 18112 / P1704

Factory service manual diagram




Note on DTC 18112 / P1704:
^ With the brake pedal depressed and simultaneous full depression of the accelerator pedal as far as Kickdown (Wide Open Throttle) this DTC can be displayed erroneously.

01L, 5 Speed A/T AWD



DTC 18112 / P1704

Factory service manual diagram




Note for DTC 18112 / P1704:
^ Condition for detecting DTC: Throttle valve signal OK, throttle valve value less than 25% and kickdown input at Transmission Control Module (TCM) has short circuit to Ground (GND) (corresponds to kickdown signal) or plus (B+),engine must run.
^ Shirt circuit to plus (B+) between Kickdown Switch -F8 and Transmission Control Module (TCM) cannot be recognized by OBD.

01J, Constantly Variable Transmission (CVT)



DTC 18112 / P1704

Factory service manual diagram




Note on DTC 18112 / P1704:
^ With the brake pedal depressed and simultaneous full depression of the accelerator pedal as far as Kickdown (Wide Open Throttle) this DTC can be displayed erroneously.

Supporting Diagrams & Locations

Reference material from the factory manual for this diagnostic procedure.

Diagram

2.7L Turbo

Diagram

4.2L

Diagram

2.7L Turbo

Diagram

4.2L

Diagram

2.7L Turbo

Diagram

4.2L

Location

ACURA

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Location

Airbag Or Pyrotechnic Safety Belt Deployment, Inquiries (GROUP 69, NO. 97-03)

Location

00 Software Version Management (SVM), Operating Instructions (GROUP 00, NO. 21-55)

Related Procedures

Procedure

Adjusting door component carrier

Procedure

Adjusting door component carrier

Procedure

Adjusting door component carrier