B1160

DTC B1006: MICU Lost Communication with Door Multiplex Control Unit Door Lock Switch Message

1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back ON.
3. Check for DTCs using the HDS.

Is DTC B1006 indicated?

YES - Go to step 2.

NO - Intermittent failure, the door multiplex control unit is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition and the charging system.

4. Check for DTCs in the gauge control module and relay module using the HDS.

Is DTC B1160 and B1058 indicated?

YES - Go to Door Multiplex Control Unit Input Test.

NO - Check for an open or a short to power or ground in the communication circuit between the MICU and the door multiplex control unit. If the circuit is OK, replace the MICU. If the circuit is bad repair the open, or short to power or ground.

DTC B1160: Gauge Control Module Lost Communication (Door Lock Switch Message) with the Door Multiplex Control Unit

1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back ON.
3. Check for DTCs by selecting the DTCs MENU (DTCs) from the HDS.

Is DTC B1160 indicated?

YES - Go to step 4.

NO - Intermittent failure. The gauge control system is OK at this time. Check pinfits and connections.

4. Check for DTCs by the DTCs MENU (DTCs) of the HDS.

Is DTC B1006 or B1058 indicated?

YES - Go to Door Multiplex Control Unit Input Test.

NO - Go to Gauge Control Module Input Test.