B1155

DTC B1007: MICU Lost Communication with the Combination Switch Control Unit (Headlight Switch Message)

1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back ON.
3. Check for DTCs using the HDS.

Is DTC B1007 indicated?

YES - Go to step 4.

NO - Intermittent failure, the MICU is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition and the charging system.

4. Check for DTCs of the gauge control module and relay control module using the HDS.

Is DTC B1155 and B1062 indicated?

YES - Go to the Combination Switch Control Unit Input Test.

NO - Check for an open, or a short to power or ground in the communication circuit between the MICU and the combination switch control unit. If the circuit is OK, replace the MICU. If the circuit is bad, repair the open, or short to power or ground.

DTC B1155: Gauge Control Module Lost Communication (Headlight Switch Message) with the Combination Switch Control Unit

1. Clear the DTCs using the HDS.
2. Cycle the ignition switch to OFF and then back ON.
3. Check for DTCs by selecting the DTCs MENU (DTCs) from the HDS.

Is DTC B1155 indicated?

YES - Go to step 4.

NO - Intermittent failure. The gauge control system is OK at this time Check pinfits and connections.

4. Check for DTCs by selecting the DTCs MENU (DTCs) from the HDS.

Is DTC B1007 or B1062 indicated?

YES - Go to Combination Switch Control Unit Input Test.

NO - Go to Gauge Control Module Input Test.