DTC B1127: Driver's Door Key Cylinder Switch Signal ErrorNOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN system diagnosis test mode A.
1.
Clear the DTCs with the HDS.
2.
Turn the ignition switch OFF, and then back ON (II).
3.
Operate the driver's door key cylinder several times.
4.
Check for DTCs with the HDS.
Is DTC B1127 indicated?
YES - Go to step 5.
NO - Intermittent failure. The driver's door key cylinder system is OK at this time. Check for shorted wires.
5.
With the driver's door key cylinder in the neutral position, select SECURITY from the BODY ELECTRICAL SYSTEM SELECT MENU, and enter the DATA LIST.
6.
Check the ON/OFF information of the Driver's Door Key Cylinder Switch (LOCK) and Driver's Door Key Cylinder Switch (UNLOCK) in the DATA LIST.
Are both information indicators OFF?
YES - Go to step 7.
NO - Go to step 11.
7.
Turn the driver's door key cylinder to the LOCK and UNLOCK positions with the ignition key and check the ON/OFF information of the Driver's Door Key Cylinder Switch (LOCK) and Driver's Door Key Cylinder Switch (UNLOCK) in the DATA LIST.
Is the Driver's Door Key Cylinder Switch (LOCK) (Driver's Door Key Cylinder Switch (UNLOCK)) information indicator ON when the key cylinder is in the LOCK (UNLOCK) position, and OFF when the key is returned to the neutral position?
YES - Faulty door multiplex control unit; replace the power window master switch.
NO - Go to step 8.
8.
Turn the ignition switch OFF.
9.
Disconnect the driver's door key cylinder switch 3P connector, and the power window master switch connector A (22P).
10.
Check for continuity between the No. 3 (LOCK) terminal and the No. 1 (UNLOCK) terminal of the driver's door key cylinder switch 3P connector.
Is there continuity?
YES - Repair an open in the WHT/RED (LOCK) or WHT (UNLOCK) wire.
NO - Faulty driver's door key cylinder switch.
11.
Disconnect the driver's door key cylinder switch 3P connector.
12.
Check the ON/OFF information of the Driver's Door Key Cylinder Switch (LOCK) and Driver's Door Key Cylinder Switch (UNLOCK) in the DATA LIST.
Are both information indicators OFF?
YES - Faulty driver's door key cylinder switch.
NO - Go to step 13.
13.
Turn the ignition switch OFF.
14.
Disconnect the driver's door key cylinder switch 3P connector.
15.
Check for continuity between the No. 3 (LOCK) and No. 1 (UNLOCK) terminals of the driver's door key cylinder switch 3P connector and body ground.
Is there continuity?
YES - Repair a short in the WHT/RED (LOCK) or WHT (UNLOCK) wire.
NO - Faulty door multiplex control unit; replace the power window master switch.
