P0703

Diagnostic Trouble Code (DTC) tables

Note:
^ The following table contains all possible malfunctions that are recognized by the Transmission Control Module (TCM) -J217- and displayed by the VAG 1551 or VAG 1552 Scan Tools (ST) when the Diagnostic Trouble Code (DTC) memory is checked.
^ If malfunctions occur occasionally or if the DTC memory was not erased after corrections were made, these malfunctions are indicated as "sporadic" for a specified amount of time.
^ The DTC is printed out in the "Rapid data transfer" mode only when the printer of the VAG 1551 Scan Tool is switched on. Example: DTC 17087 P0703 (VAG code and P-code)
^ If components were determined to be malfunctioning when the DTC memory is checked, check the wiring and components for short circuit and open circuit according to latest wiring diagram.

Note:
^ Dcy = Driving cycle.
^ Explanation for emission warning light Multi-function Indicator Lamp (MIL).
^ The "MIL" column in the DTC table indicates the condition for which the MIL will be switched on. If, for example, "2 Dcy" is indicated, it means that the MIL will be switched on after 2 driving cycles. If "Off" is indicated, the malfunction has no influence on the MIL. If "On" is indicated, the MIL will be switched on immediately when the malfunction occurs.





Scan Tool Print-out Part 1 of 9





Scan Tool Print-out Part 2 of 9





Scan Tool Print-out Part 3 of 9





Scan Tool Print-out Part 4 of 9





Scan Tool Print-out Part 5 of 9





Scan Tool Print-out Part 6 of 9





Scan Tool Print-out Part 7 of 9





Scan Tool Print-out Part 8 of 9





Scan Tool Print-out Part 9 of 9

DTC 17087 / P0703

1) The brake pedal is recognized as not being depressed, which means that the Shift Lock solenoid -N110 is not released when the brake pedal is depressed and the selector lever cannot be moved out of position P or N (the shift lock solenoid is constantly active).

2) Shift Lock solenoid -N110 cannot be activated in positions P and N, which means that the selector lever can be moved out of positions P and N without depressing the brake pedal. (The shift lock solenoid is constantly not active).

Note for DTC 17087 / P0703:
^ The malfunction is preset when the ignition is switched on. The preset DTC is erased after the brake pedal has been activated once if the Brake Switch -F is OK

^ Step on the brake pedal before checking the DTC memory to erase the preset DTC.